The use of ice machine - 1 water for ice needs to add salt (the jargon is called dosing) as much as the amount! See how much the amount of ice is modulated by the pump (piston pump). 2, the ice machine should be installed away from the heat source, no direct sunlight, good ventilation, the ambient temperature should not exceed 35 degrees Celsius, to prevent the ambient temperature from being too high, resulting in poor heat dissipation of the condenser, affecting the ice making effect. The floor where the ice machine is installed should be solid and flat, and the ice machine must be level, otherwise it will cause no ice and noise during operation.
3. The gap between the back and left and right sides of the ice making machine should be no less than 30cm, and the top gap should be no less than 60cm.
4, the ice machine should use an independent power supply, dedicated line power supply and equipped with fuses and leakage protection switches, and must be reliably grounded.
5. The water of the ice machine should meet the national drinking water standard, and a water filtration device should be installed to filter the impurities in the water to avoid clogging the water pipe and polluting the water tank and the ice mold. And affect the performance of ice making.
6. When cleaning the ice machine, turn off the power supply. Do not use the water pipe to directly align with the body. Use a neutral detergent to scrub. Do not use acidic or alkaline solvents to clean.
7. The ice machine must unscrew the inlet hose head for two months to clean the inlet valve screen to prevent the sand mud impurities from clogging the water inlet, which causes the water intake to become smaller, resulting in no ice.
8. The ice machine must clean the surface of the condenser every two months. If the condensation is poor, the compressor components will be damaged. When cleaning, use a vacuum cleaner, a small brush, etc. to clean the condensed surface oil dust. Do not use a sharp metal tool to clean it to avoid damaging the condenser.
9. The water pipes, sinks, storage refrigerators and protective film of the ice machine should be cleaned every two months.
2022 New Laser Distance Sensor
At the start of 2022, JRT introduce our customers a batch of new series laser distance measurer sensor(S92-20m, S91, BA6A-150m, BA6A-20Hz, M703A-8Hz, U81-10m etc.). Especially S91(RS485 interface and software Rx Tx protocol) and S92(RS232 interface) ip54 enclosure distance sensor model, custoemrs would like to use it in their industrial automation solutions,according to the ip54 waterproof protection level, well protect laser, Wide Voltage 5~32V(Optimize for industrial using), and easy-to-install.
If you are interested in JRT more laser measuring sensors, or you would like buy qty 2 quotation for trial basis, please welcome to contact us.
Kind regards
JRT Team
Chengdu JRT Main Ranging Modules: Industrial Laser Distance Sensors, Laser Rangefinder Sensor , Tof LiDAR Sensors.
laser measuring,infrared sensor,distance measurers,ir range sensor,laser sensor
Chengdu JRT Meter Technology Co., Ltd , https://www.jrt-measure.com