Maintenance and use of tractor gearbox

The gearbox is an important part of the tractor. The main cause of the failure is the deformation and wear of the gearbox's main components, such as shafts, bearings, gears, forks, locking pins and springs. If the maintenance is not timely or the use of improper operation, such as the oil surface is too low, the oil is not replaced in time, causing poor lubrication, oil temperature is too high; improper shift operation, so that the gear end surface injuries, resulting in shifting difficulties, etc. , will cause rapid changes in the state of the gearbox technology. Therefore, timely maintenance and proper operation are the main ways to reduce transmission failures and extend service life. 1. Always check the tightness of each connection part of the transmission and tighten it if necessary; always check for oil leakage or oil leakage at the shaft end oil seal and external joint. If necessary, replace the failed oil seal and paper pad and tighten the screws. Regularly change the new oil. When changing the oil, the dirty oil should be discharged with heat and cleaned with diesel oil or kerosene. The newly changed oil should meet the required standards. 2. When shifting gears, manipulating the gearshift levers cannot use excessive force to avoid teething and damage to the components such as the shifting fork; after the clutch is completely disengaged, the gears are shifted so as not to damage the gears; when carrying out the transportation work, the gears can be shifted without stopping, but Proficiency in operation; parking shifts when performing field operations. The engagement of the clutch should not be too fast, so as to avoid the impact load of the transmission parts, the early spalling of the tooth surface, the crushing of the transmission spline shaft surface, and even the breaking of the spline shaft. It is strictly forbidden to overcome the heavy load or overcome the obstacles by using the method of slamming the clutch pedal to reduce the impact abrasion of the gear.

Patch For Diarrhea

Medical Cold Patch
Patch for diarrhea
[Name] Medical Cold Patch
[Package Dimension] 5cm 4pieces/box
The pain relief patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application] For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give a fast relief for diarrhea.
[How To Use a Patch]
Please follow the Schematic Diagram. One piece, one time.
The curing effect of each piece can last for 6-8 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
Store below 30c in a dry place away from heat and direct sunlight.







Patch For Diarrhea,Medicated Patches For Arthiritis,Plaster For Diarrhea,Pad For Diarrhea

Shandong XiJieYiTong International Trade Co.,Ltd. , https://www.xjplaster.com

Posted on