Before the centrifuge is operated, the power should be cut off and the centrifuge brake should be loosened first. You can manually turn the drum to see if there is any bite. Check for other parts of the area for looseness and abnormality.
Turn on the power and start it in a clockwise direction (usually about 40-60 seconds from standstill to normal operation). Usually, each equipment must be empty for about 3 hours after it arrives at the factory. It can work without abnormal conditions.
Place the material as evenly as possible. Must be operated by a person, the capacity must not exceed the rated amount. Never overspeed the machine to avoid affecting the life of the machine. After the machine is started, if there is an abnormal situation, it must be stopped for inspection and repaired if necessary. The centrifuge is running at high speed, so it is not possible to touch the drum with the body to prevent accidents.
The mesh number of the filter cloth should be determined according to the size of the solid phase particles of the separated material, otherwise the separation effect will be affected. In addition, when installing the filter cloth, insert the filter cloth sealing ring into the drum sealing groove to prevent the material from running in.
After the machine is used, it should be cleaned and kept clean. Do not separate the non-preservative centrifuge from the highly corrosive materials; in addition, strictly follow the equipment requirements and regulations, and the non-explosion-proof centrifuge should not be used in flammable or explosive places.
This article was edited by the laboratory instrument - Hunan Gilson Technology Development Co., Ltd.
Antigen Test Kit
Guangdong Hecin Scientific, Inc. , https://www.hecinscientific.com